Frequency-Division DuplexingFrequency-division duplexing

Frequency-Division DuplexingFrequency-division duplexing (FDD) means that the transmitter and receiver operate at different carrier frequencies. The term is frequently used in ham radio operation, where an operator is attempting to contact a repeater station. The station must be able to send and receive a transmission at the same time, and does so by slightly altering the frequency at which it sends and receives. This mode of operation is referred to as duplex mode or offset mode.

Uplink and downlink sub-bands are said to be separated by the frequency offset. Frequency-division duplexing can be efficient in the case of symmetric traffic. In this case time-division duplexing tends to waste bandwidth during the switch-over from transmitting to receiving, has greater inherent latency, and may require more complex circuitry.

Another advantage of frequency-division duplexing is that it makes radio planning easier and more efficient, since base stations do not "hear" each other (as they transmit and receive in different sub-bands) and therefore will normally not interfere with each other. On the converse, with time-division duplexing systems, care must be taken to keep guard times between neighboring base stations (which decreases spectral efficiency) or to synchronize base stations, so that they will transmit and receive at the same time (which increases network complexity and therefore cost, and reduces bandwidth allocation flexibility as all base stations and sectors will be forced to use the same uplink/downlink ratio)

November 17, 2011

Continue